S
scoobydoo
Guest
Well you know when you think something will never happen to you and it does?
I believe the zipper ,from the 'official' case, had been pressing against the front corners of my Pandora every time I closed it.
As many of you know, these cases take quite some working in to get a proper fit. My Pandora always fit rather tightly in the official case.
At times it would not fit and I had to stretch the case out repeatedly to get it in. Though it was advised to buy a generic case, I shunned the advice and now I am paying for it.
Apparently the zipper was making way too much contact on the right corner of the Pandora and hence the crack appeared from the inside of the lid throughout the outer side of that corner. So I used a adhesive bonding agent to seal the crack. Then I noticed the crack had traveled upward. I then sealed that portion and now the creeping crack appears to have ceased for now. However being the aesthetic type ,when it come to my gizmos, the repair looks like a poor make up job . I hope the crack does not travel further.
There have been no drastic temperature changes here. I had a feeling when I would close the Pandora that perhaps all the friction might cause a crack especially when the zipper passed over those corners. Stupid me I suppose :mellow: .
The unit is still under warranty and I was wondering if Ed would have it in his heart to replace the case? If not I understand your situation for this was bought at the UK shop. I will pay if necessary.
I do not want to undertake this myself. Not to appear unmanly but I am scared to take this apart.
Perhaps this should have been in the support section? Will the moderator do so if deemed necessary?
Regretfully,
Scooby.
I believe the zipper ,from the 'official' case, had been pressing against the front corners of my Pandora every time I closed it.
As many of you know, these cases take quite some working in to get a proper fit. My Pandora always fit rather tightly in the official case.
At times it would not fit and I had to stretch the case out repeatedly to get it in. Though it was advised to buy a generic case, I shunned the advice and now I am paying for it.
Apparently the zipper was making way too much contact on the right corner of the Pandora and hence the crack appeared from the inside of the lid throughout the outer side of that corner. So I used a adhesive bonding agent to seal the crack. Then I noticed the crack had traveled upward. I then sealed that portion and now the creeping crack appears to have ceased for now. However being the aesthetic type ,when it come to my gizmos, the repair looks like a poor make up job . I hope the crack does not travel further.
There have been no drastic temperature changes here. I had a feeling when I would close the Pandora that perhaps all the friction might cause a crack especially when the zipper passed over those corners. Stupid me I suppose :mellow: .
The unit is still under warranty and I was wondering if Ed would have it in his heart to replace the case? If not I understand your situation for this was bought at the UK shop. I will pay if necessary.
I do not want to undertake this myself. Not to appear unmanly but I am scared to take this apart.
Perhaps this should have been in the support section? Will the moderator do so if deemed necessary?
Regretfully,
Scooby.
Last edited: