ninjak
Still Fresh
On boot-up, my gp2x seems to be stuck in a slower mode for about five minutes before full speed is reached. It's a sudden jump, not a smooth transition. I haven't measured the time yet to see if it's consistent, but it's somewhere on the five minute mark. I can tell right away, playing drmd is stuck at about 12-20 fps until the jump where I hit 50-60 fps all the time. It never seems to revert until the unit is shut off again. Has anyone else experienced this ?
Some component may not be starting properly and the sudden jump may be due to a process timing out.
I'm going to do some further experimenting to measure this time.
It also happens with Nes2x, Methane and UQM so for that I've noticed. Wasn't noticable on Scumm.
Using Firmware 1.1.0
Also, sometimes the sound doesn't seem to initialize properly at boot-up and when this happens, it seems the gp2x doesn't pick up full speed until it's brought back to the menu. Maybe it has something to do with modules not loading properly and Linux continously polling to try to remedy that.
As for the LCDTweak tool, it reports 199 MHz at startup. But the problem persists. I'm pretty sure it's related to the inconsistency in the boot time as well.
Some component may not be starting properly and the sudden jump may be due to a process timing out.
I'm going to do some further experimenting to measure this time.
It also happens with Nes2x, Methane and UQM so for that I've noticed. Wasn't noticable on Scumm.
Using Firmware 1.1.0
Also, sometimes the sound doesn't seem to initialize properly at boot-up and when this happens, it seems the gp2x doesn't pick up full speed until it's brought back to the menu. Maybe it has something to do with modules not loading properly and Linux continously polling to try to remedy that.
As for the LCDTweak tool, it reports 199 MHz at startup. But the problem persists. I'm pretty sure it's related to the inconsistency in the boot time as well.