DC adapter problem


tix

Still Fresh
Joined
May 16, 2003
Messages
86
ÏÊ here is the story...
I have recently bought an AC-DC adapter for my gp32 (500 mA max)
it has a volt changer from 1.5 to 12, so far so good
I put the switch to 3 Volts I choose the correct polarity and I switch my gp32 on
but the quality of the picture is bad !!! it flickers like it has a very low refresh rate !!!
What is the problem ????? Is my adapter low quality or what ????
 
Not sure on what your adapter is like, but i also use a multi-voltage one (the kind that has slot on connectors at the end) and this runs my GP fine

Is the polarity definately set to - ? (probably blow up if not, but just checking :p )
 
It may be that the adapter is faulty. If the voltage level is not consistant, it can cause the sort of problems you're on about...

May be worth getting it swapped?
 
Back
Top