jedi23
Very Active Member
- Joined
 - Aug 11, 2020
 
- Messages
 - 291
 
I flashed pyra-42.img with Etcher on an SD card so that I can try out a few things while the system on the eMMC remains unaffected.
When I inserted the SD card in the left slot, the Pyra did boot, the config tool started and shutted the system down after completion. So far so good.
However, when I now press the Power key, nothing happens and only the logo on the back side lights green. I tried several times with shutting off by holding the Power key for 10 sec or by removing the battery. Even when I reflashed the SD card, the Pyra doesn't boot anymore from SD!
When I remove the SD card, the Pyra boots normally from the eMMC.
Why booted my Pyra only once from SD card and how can I fix it?
				
			When I inserted the SD card in the left slot, the Pyra did boot, the config tool started and shutted the system down after completion. So far so good.
However, when I now press the Power key, nothing happens and only the logo on the back side lights green. I tried several times with shutting off by holding the Power key for 10 sec or by removing the battery. Even when I reflashed the SD card, the Pyra doesn't boot anymore from SD!
When I remove the SD card, the Pyra boots normally from the eMMC.
Why booted my Pyra only once from SD card and how can I fix it?
			
				Last edited: 
			
		
	
								
								
									
	
								
							
							
	