Boot Configuration


vega01

Still Fresh
Joined
Mar 20, 2009
Messages
17
Question to MWeston probably:

What is the hardware configuration of sys_boot pins on Pandora board? I mean what are the logical levels during Power-On Reset? If it would be e.g. 0b11000 then according to OMAP manual it should be possible to boot from UART3 on Power-On Reset instead of MMC1, which is convenient for frequent testing some low level code.
 
Bosbeetle said:
Did you check the hackers manual (just to be sure)

http://www.openpandora.org/downloads/PANDORA_Hackers_manual_v100.pdf

Yes.
 
Last edited by a moderator:
urjaman said:
http://blogs.distant-earth.com/wp/?p=79


Thanks a lot! I need to check this blog more frequently. Just forgot that it exists.
 
Last edited by a moderator:
Back
Top